Loading...
Loading...
Reverse Camera on Non-Touchscreen Unit is an advanced change that rewards careful backups for 2015–2020 Ford F-150 trucks, applied with FORScan over an OBD-II adapter. Enables reverse camera support on supported non-touchscreen units. It is fully reversible and typically takes about 10 minutes to write once your worksheet is in hand.
The change touches the Front Control Display Interface Module (FCDIM), and your F-Config worksheet lists all 1 as-built code row with the module, address, and target value. Each row includes a blank for your original value so you can back up before writing changes and roll back later. Supports a reverse camera retrofit on compatible trucks.
Supports a reverse camera retrofit on compatible trucks
Worksheet rows
1
Modules
1
Estimated time
~10 min
Compatibility
2015-2020
The DIY process from start to finish — backup-first and, where possible, reversible.
Before changing anything, use FORScan to read and record the current value of each of the 1 row in the Front Control Display Interface Module (FCDIM). Your worksheet leaves a blank beside every row for exactly this.
Enter the 1 target row from your worksheet one at a time. Most owners finish Reverse Camera on Non-Touchscreen Unit in about 10 minutes with a laptop and a FORScan-compatible OBD-II adapter.
Turn the key off and back on, then confirm the change behaves as expected before moving on. If anything looks off, stop and compare against the originals you recorded.
Because Reverse Camera on Non-Touchscreen Unit is fully reversible, you can put every original value back later and return to stock whenever you want.
Review year-specific FORScan worksheet context before adding this mod to your build.
Make backups, understand the tool requirements, and review the FAQ before applying worksheet values.
Customers get a clean worksheet with original-value blanks, target values, completion checks, and module notes.
| Module | Address | Target value | Notes |
|---|---|---|---|
| FCDIM | 7A5-01-01 | x2xx xxxx xxxx | Run BdyCM LIN New Module Initialization after writing |
Requires careful backups and confidence working in FORScan.
It is rated advanced. It is well within reach for a careful DIYer, but back up your original values and work through the worksheet one row at a time.
Yes. This change is fully reversible as long as you record your original as-built values first. Your worksheet leaves a blank for each original value so you can roll back to stock.
It writes 1 code row to the Front Control Display Interface Module (FCDIM). Each row is listed in your worksheet with its address and target value.
Most owners finish Reverse Camera on Non-Touchscreen Unit in about 10 minutes once they have the worksheet, a laptop, and a FORScan-compatible OBD-II adapter.
Reverse Camera on Non-Touchscreen Unit applies to 2015–2020 F-150 trucks. Compatibility can still vary by trim, package, and module software version, so confirm against your own as-built data.
Only use when compatible camera hardware has been installed.
Other FORScan changes in the same category you can add to the same worksheet.
Allows navigation and text reading while vehicle is moving
Shows heated/cooled seat controls on home and climate screen
Shows heated steering wheel control on home and climate screen
Allows stereo to keep playing after turning off engine
Disables power outlet timeout
Allows stereo use without accessory mode on 2015 F-150s